Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

clock rate

can anyone tell me more about clock rate topic, i m confuse with this one. is this command is only used with Cisco router?

Pls reply

1 REPLY
Silver

Re: clock rate

Hi ,

To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate command in interface configuration mode. To remove the clock rate if you change the interface from a DCE to a DTE device, use the no form of this command. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.

Below link gives info about how to set clock rate for ATM interfaces and what is the need to setup clock rate..

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/inter_r/int_a1g.htm#wp1142413

Hope it helps you.

Thanks,

satish

711
Views
0
Helpful
1
Replies
CreatePlease to create content