We are trying to cluster two 2960's:
SW1 - C2960-24-TC-S
SW2 - C2960-24-LT-L
We setup SW1 as the cluster commander with the following command:
cluster enable STACK1
When we try to add the other switch as a cluter member:
cluster member mac-address 0023.ab0f.a880
We get "member unreachable" error message
The two switches are connected via GI0/2 (on both switches).
When we run SH MAC-ADDRESS-TABLE on SW1 se do not see the base mac address of SW2
We attached a laptop to SW2 and traffic appears to go from laptop --> SW2 --> SW1
Any ideas?
