Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

collision detection

Hi, I have developed a Ethernet network of 100 computers, how to explore the collisions in the same network with Packet Tracer6. Thank you in advance.

Everyone's tags (1)
2 REPLIES
Hall of Fame Super Blue

"sh interface <int>" will

"sh interface <int>" will show you the collisions per interface.

Note that if you are using switches to connect up your devices and you are running the ports in full duplex you should not see any collisions.

Jon

New Member

Thanks i use a half duplex

Thanks i use a half duplex network but where am I supposed to write this command using switch command-line interface (CLI) or something else?

47
Views
0
Helpful
2
Replies
CreatePlease login to create content