kashif.rizvi wrote:
Hello all,
I would like to know if there is any config required to enable last 8 combination ports of Cisco 4948 Switch.
I dont have a requirement for GBIC and would like to use ports from Gi1/45 to 48 thru regukar RJ45 but they are showing down.
Seems like it is currently set for GBIC. Below is the interface status output for the ports:
Gi1/45 notconnect 705 full 1000 No Gbic
Gi1/46 notconnect 1 full 1000 No Gbic
Gi1/47 notconnect 1 full 1000 No Gbic
Gi1/48 notconnect 1 full 1000 No Gbic
Kindly advice if there is any way to activate the Gigabit RJ45 ports?
4948(config)# int range gi1/45 - 48
4948(config-if-range)# media-type rj45
Jon
