Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ian
New Member

Combining two different ip ranges in a nat pool

Hi Im trying to figure out how I would combine the ranges:

111.111.111.2 to 111.111.111.254

and

222.222.222.2 to 222.222.222.254

into the same nat pool in a router.

How would I do this?

Thanks,

Ian

:)

2 REPLIES

Re: Combining two different ip ranges in a nat pool

Is the above ACL for internal network or for the NAT outside IP ?

ian
New Member

Re: Combining two different ip ranges in a nat pool

Sorry for the confusion. I really wasnt clear in that first post.

Those are examples of the public ip addresses available to form the pool of public ip addresses to represent a large amount of private ip addresses.

Netmask is 255.255.255.0. They are examples.

Currently I have a nat pool with the first range assigned and its working fine. But the second range isn't part of the first range's network (two class C). I tried creating a pool and in the sub interface using the address command to define the ranges, but the results were rather destructive, so I'm not sure whether its because it can't be done that way, or whether it can be done that way and there is something else wrong.

Thanks for your help,

Ian

:)

257
Views
0
Helpful
2
Replies