Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Command conversion from CatOS 8.4 to IOS 15.0SY

Upgrading an old 6509 running CatOS  to a new 6509E running IOS 15.0SY.  The switch is a core switch that does not have any phones plugged into it but does support voip traffic across the enterprise.  The qos on the switch is as follows

#qos

set qos enable

set qos map 1p2q2t tx 1 2 cos 0

set qos map 1p2q2t tx 2 1 cos 2

set qos map 1p2q2t tx 2 1 cos 3

set qos map 1p2q2t tx 2 2 cos 6

set qos wrr 1p2q2t 30 70

set qos txq-ratio 1p2q2t 30 40 30

set qos wred 1p2q2t tx queue 1 40:80 80:100

set qos wred 1p2q2t tx queue 2 70:80 80:100

What type of qos should I use on the new switch to achieve the same functionality as the old switch?

Thanks

1 REPLY
Silver

Command conversion from CatOS 8.4 to IOS 15.0SY

Hi

The answer will actually depend on what traffic you want to prioritize and how much you want to prioritize.

Or you have special requirements like limiting the bandwidth or something like that.

I'd say at the initial stage auto qos is the best option and in case you face any issues tweak it accordingly as you go.

Thanks

Ankur

"Please rate the post if found useful"

128
Views
0
Helpful
1
Replies