Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

command for changing gbic cards on switch

What command to use to change gbic cards on cisco 4506 switch?

2 REPLIES
VIP Super Bronze

command for changing gbic cards on switch

You can replace the card without using any commands.   The cards are hot swapable.

HTH

Cisco Employee

command for changing gbic cards on switch

Reza,

Not sure what exactly is the question...but never the less yes as mentioned by you that we dont have any cmd to replace the card.

But I was thinking is the question beeing asked to change the Gbic from 10G to 1 Gig?

If yes then as you know the below command would do the trick:

#conf t

#hw-module module X port-group gig-interface ( This will convert 10 gig to 1 gig).

Ref:http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/sw_int.html

HTH

Regards

Inayath

144
Views
0
Helpful
2
Replies
CreatePlease to create content