Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Command that lists line cards model

Hi All,

Is there any command that shows all the line cards model that have been installed for each 4500 slot?

The "show interface" command is not enough as for example it will not allow to understand if it's a classic or a E-Series line card.

Thanks,

Vin

  • LAN Switching and Routing
2 ACCEPTED SOLUTIONS

Accepted Solutions
Bronze

Re: Command that lists line cards model

Hi Vin,

show module is good command to reveal details about switch related cards

show diag is a good for the Cisco rotuer environment

If helpful, rate it!!

Regards

Frank

Purple

Re: Command that lists line cards model

Show idprom all  or show mod will show you what you need .

4 REPLIES
Bronze

Re: Command that lists line cards model

Hi Vin,

show module is good command to reveal details about switch related cards

show diag is a good for the Cisco rotuer environment

If helpful, rate it!!

Regards

Frank

New Member

Re: Command that lists line cards model

Thanks, exactly what I was looking for!

Post rated.

Regards,

Vin

Purple

Re: Command that lists line cards model

Show idprom all  or show mod will show you what you need .

New Member

Command that lists line cards model

I'm using:

#show inventory

204
Views
0
Helpful
4
Replies