Re: Command to find out supervisor card being used
Thanks very much for that. I'm realtively new to the 6500 switches. Can you please point me to somewhere that explains why the routing module is separate from the switch.
Also when I telnet to the switch does that mean I am connecting to the supervisor card?
Additionally I assume you can change supervisor cards easily. If I do change my card where is my config stored, will I lose that? Also how do I know if the backup supervisor card has had the running-config written to it, that is if the cofig is actually stored on supervisor cards?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.