Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

command to get status of CRC errors

Hi,

i Have 6509 switch with 4module of 48 port each and i need to get status of CRC erros for each interface. does we have any command to get desire result. thanks

2 ACCEPTED SOLUTIONS

Accepted Solutions
Bronze

Re: command to get status of CRC errors

Hi Roger,

If you want to know the only CRC errors of all up interfaces use this command...

sh interfaces | in up|CRC

HTH....Please rate all helpful posts

*aijaz*

Purple

Re: command to get status of CRC errors

If its IOS then its "show interface counters errors " . If catos then its "show port counters" .

7 REPLIES

Re: command to get status of CRC errors

Hi Roger,

If you want to know it on a per interface basis, then you need to enter the "show interface fastethernet x/y" command.

The output of this command will show you the errors classified by type, including the CRC errors.

Cheers:

Istvan

Bronze

Re: command to get status of CRC errors

Hi Roger,

If you want to know the only CRC errors of all up interfaces use this command...

sh interfaces | in up|CRC

HTH....Please rate all helpful posts

*aijaz*

New Member

Re: command to get status of CRC errors

thanks dud resolved my issue

New Member

Re: command to get status of CRC errors

No Actually i want to know it for all interface via single command like we have range command. any suggestion

Bronze

Re: command to get status of CRC errors

I'm glad that it solved ur issue....and thanks for using the rating system..

Re: command to get status of CRC errors

Hi,

You can use show port module/port-number to find out exactly of what you need.

there are few options you can use, for example

1 show port 8/42

...will give all information for the port 42 on module

2 You can also use show port 8

this will give required information for all the ports on mudule 8

3 You can also use show port

and this will give required information for all the port on the entire Chassis..

HTH

Shaheen

Purple

Re: command to get status of CRC errors

If its IOS then its "show interface counters errors " . If catos then its "show port counters" .

8326
Views
5
Helpful
7
Replies
CreatePlease to create content