Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

command to leave switch description blank

            What is the command to leave description blank?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: command to leave switch description blank

Hi,

Very easy just remove the description.

As you know that by default there would be no description configured on the port, But if someone have configured it and you want to remove  the same you can do it by just removing the same.

Eg:

Router#sh run int e0/0

Building configuration...

!

interface Ethernet0/0

description SERVER >>>>>>>>>>>>> Description has been confiugred as Server.

ip address 192.168.0.1 255.255.255.0

end

2- Now I am removing that description:

Router(config-if)#int e0/0

Router(config-if)#no des

Router(config-if)#no description

Router(config-if)#do sh run int e0/0

interface Ethernet0/0

ip address 192.168.222.27 255.255.255.248

end >>>>>>>>>>>>> No description now.

HTH

Regards

Inayath

*Plz rate this thread is this answerd yoru query.

2 REPLIES
Cisco Employee

Re: command to leave switch description blank

Hi,

Very easy just remove the description.

As you know that by default there would be no description configured on the port, But if someone have configured it and you want to remove  the same you can do it by just removing the same.

Eg:

Router#sh run int e0/0

Building configuration...

!

interface Ethernet0/0

description SERVER >>>>>>>>>>>>> Description has been confiugred as Server.

ip address 192.168.0.1 255.255.255.0

end

2- Now I am removing that description:

Router(config-if)#int e0/0

Router(config-if)#no des

Router(config-if)#no description

Router(config-if)#do sh run int e0/0

interface Ethernet0/0

ip address 192.168.222.27 255.255.255.248

end >>>>>>>>>>>>> No description now.

HTH

Regards

Inayath

*Plz rate this thread is this answerd yoru query.

New Member

command to leave switch description blank

Perfect!!!!!   Just tried it... worked like a charm.....

5702
Views
0
Helpful
2
Replies
CreatePlease login to create content