Re: Command used to allow 3rd party transceiver on 2960 switch
regarding the "service unsupported-transceiver" command I learnt the following. This command is intended as a last-resort to try to use a third party Optic product to work with Cisco devices. Cisco does not gurantee the working of the third party module with this command. If you wish to use this feature, I would strongly recommend you to read the warning that will be displayed when you execute the command.
Warning: When Cisco determines that a fault or defect can be traced to the use of third-party transceivers installed by a customer or reseller, then, at Cisco's discretion, Cisco may withhold support under warranty or a Cisco support program. In the course of providing support for a Cisco networking product Cisco may require that the end user install Cisco transceivers if Cisco determines that removing third-party parts will assist Cisco in diagnosing the cause of a support issue.
Here is a link that states Cisco's policy on third party modules and warranty information for your reference.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.