01-16-2008 05:52 AM - edited 03-05-2019 08:30 PM
Hi,
on one port-channel interface we configured several vlans to have special port costs.
In the config now there are two lines:
spanning-tree vlan 6-7,9,25,28,32,51,57,70-71,73,80-88,92-93,102-105,108 cost 5
spanning-tree vlan 121-128,451,465,469 cost 5
Does anybody know why there are two lines instead of one?
Best Regards,
Thorsten Steffen
01-22-2008 10:29 AM
Its depends upon the platform module and software version you are using in network. So its shows like that.
01-23-2008 12:32 AM
The output was seen on a WS-SUP720-3B IOS Version 12.2(18)SXF12.
Regards,
Thorsten Steffen
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: