04-28-2010 06:19 AM - edited 03-06-2019 10:50 AM
Hi I am trying to implement qos on catalyst 6500 with WS-6148 A - Ge-45AF line card. I have configured qos on the port levels but not finding any suitable command other than sh queueuing int g slot/port in order to see the various COS marked traffic entrring the queue /threshold combinations.
Kindly help.
Kas
Solved! Go to Solution.
04-28-2010 06:48 AM
If you enable and configure NetFlow you can see the QoS markings (in hex) while issuing the show mls ip detail command.
This URL is also helpful http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008074d6b1.shtml
Regards
Edison
04-28-2010 06:48 AM
If you enable and configure NetFlow you can see the QoS markings (in hex) while issuing the show mls ip detail command.
This URL is also helpful http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008074d6b1.shtml
Regards
Edison
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: