Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Commands for monitoring and troubleshooting qos in cat 6500

Hi I am trying to implement qos on catalyst 6500 with WS-6148 A - Ge-45AF line card. I have configured qos on the port levels but not finding any suitable command other than sh queueuing int g slot/port in order to see the various COS marked traffic entrring the queue /threshold combinations.

Kindly help.

Kas

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Commands for monitoring and troubleshooting qos in cat 6500

If you enable and configure NetFlow you can see the QoS markings (in hex) while issuing the show mls ip detail command.

This URL is also helpful http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008074d6b1.shtml

Regards

Edison

1 REPLY
Hall of Fame Super Bronze

Re: Commands for monitoring and troubleshooting qos in cat 6500

If you enable and configure NetFlow you can see the QoS markings (in hex) while issuing the show mls ip detail command.

This URL is also helpful http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008074d6b1.shtml

Regards

Edison

981
Views
0
Helpful
1
Replies
CreatePlease to create content