Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Commands To View Hardware State on Dropped 6500

We dropped a 6500 with no power supplies. We had to prop the bottom of the chassis with wood to get the power supplies in. What commands are available to take a look at the hardware and see what specific problems exist with the linecards, supervisor etc.?

3 REPLIES
New Member

Re: Commands To View Hardware State on Dropped 6500

Maybe try a sh module.

New Member

Re: Commands To View Hardware State on Dropped 6500

I would configure the following, "diagnostic bootup level complete" and reload the switch. This will do a complete diag and once the switch is up perform a "sh diagnostic result".

New Member

Re: Commands To View Hardware State on Dropped 6500

sh test would do.

97
Views
0
Helpful
3
Replies
CreatePlease to create content