Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Config PoE on c3750x

I am getting the error on my switch when I connect my PoE phone, I would like to know how to have the port send power to the phone. When I check the other ports on the switch that has power is outline below.

 

Error

Interface Gi2/0/48: Power Device detected: IEEE PD 
Feb 28 08:05:32.226: %ILPOWER-5-ILPOWER_POWER_DENY: Interface Gi2/0/48: inline power denied. Reason: Insufficient total available power.

 

Working PoE port.

interface GigabitEthernet2/0/7
 switchport access vlan 112
 switchport mode access
 spanning-tree portfast

  • LAN Switching and Routing
2 REPLIES
Hall of Fame Super Gold

Reason: Insufficient total

Reason: Insufficient total available power.

Please post the following complete command outputs: 

 

1.  sh version; and 

2.  sh power inline

This might seem an obvious

This might seem an obvious question but have you checked there is actually free power for the additional device?

The switch will not have an infinite amount of power and will eventually run out so if the phone needs say 6w of power but the switch only have 4w left for PoE then it will not power the phone.

 

44
Views
0
Helpful
2
Replies
This widget could not be displayed.