Config Router Cisco 2600

[favioscar69]

Hi!

After configuring a cisco router 2600 and save the Configuration using the write command and the command copy running-config startup-config, reboot the router with the reload command.

After loading the entire image appears again-System Configuration dialog-would you like to enter the initial configuration dialog? yes / no

As I can do to be saved the configuration I've made?

After configuring a cisco router 2600 and save the Configuration using the write command and the command copy running-config startup-config, reboot the router with the reload command.
After loading the entire image appears again-System Configuration dialog-would you like to enter the initial configuration dialog? yes / no
As I can do to be saved the configuration I've made?

[Daniele Giordano]

Check the config registry using the command "show ver".

The correct output must be like this:

IAD_1#sh ver

Cisco IOS Software, 2400 Software (C2430-IK9O3S-M), Version 12.4(25d), RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Wed 18-Aug-10 12:39 by prod_rel_team

... omitted..

Configuration register is 0x2102

IAD_1#

In case of different value use these commands:

IAD_1#conf t

IAD_1(conf)#config-register 0x2102

and so write mem

Regards.

[favioscar69]

Thanks a lot for you time!