Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config Router Cisco 2600

Hi!

After configuring a cisco router 2600 and save the Configuration using the write command and the command copy running-config startup-config, reboot the router with the reload command.

After loading the entire image appears again-System Configuration dialog-would you like to enter the initial configuration dialog? yes / no

As I can do to be saved the configuration I've made?

After configuring a cisco router 2600 and save the Configuration using the write command and the command copy running-config startup-config, reboot the router with the reload command.
After loading the entire image appears again-System Configuration dialog-would you like to enter the initial configuration dialog? yes / no
As I can do to be saved the configuration I've made?

2 REPLIES

Re: Config Router Cisco 2600

Check the config registry using the command "show ver".

The correct output must be like this:

IAD_1#sh ver

Cisco IOS Software, 2400 Software (C2430-IK9O3S-M), Version 12.4(25d), RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Wed 18-Aug-10 12:39 by prod_rel_team

... omitted..

Configuration register is 0x2102

IAD_1#

In case of different value use these commands:

IAD_1#conf t

IAD_1(conf)#config-register 0x2102

and so write mem

Regards.

New Member

Re: Config Router Cisco 2600

Thanks a lot for you time!

1190
Views
0
Helpful
2
Replies
CreatePlease login to create content