Config storage confusion 2504 controller with CAP702I
I've been tasked with the rollout of the above mentioned hardware, and I've managed to get so far, but it seems I cannot do a 'copy running-config startup-config' on the CAP702I Aironet access points.
ive got then registered with the controller and radios turned on but the problem is that it the power is cycled the radios turn off, I can SSH into each AP and manually turn them on and it works all fine except I shouldn't need to do that.
If anyone could give me a clue as to how to change the ap config to either store the config with radios enabled on restart on the device itself or guide me through storing the config on the 2504 controller and pointing to it on the ap devices for their startup, it would be much appreciated.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...