Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configration in 4500 catalyst switch

I have a catalyst 4507R switch. I would like to add two modules (24 port WS-X4424-GB-RJ45 and WS-X4418) in the existing 4507R switch. Do these modules are plug and play or I have to do some configurations in the supervisor? If any configuration needed then what is that?

1 REPLY
Cisco Employee

Re: Configration in 4500 catalyst switch

Hi Manoj,

Yes all line cards are plug and play and if your IOS release running on your supervisor supports these cards, they will automatically get detected and will move to OK state.

After that it is only the port configuration which you have to do on the line cards interfaces.

HTH

Ankur

*Pls rate all helpfull post

109
Views
4
Helpful
1
Replies
CreatePlease to create content