Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Configuraing NAT on SUP720

Hi,

I was trying to configure NAT between two VLANs on SUP720 based 6509 switch? Is there any constraints or is it straight forward?

Regards

Kerins

1 REPLY
New Member

Re: Configuraing NAT on SUP720

After searching Cisco site, I found out that SUP720's NAT function is 'hardware assisted'. Can anyone explain more about this?

495
Views
0
Helpful
1
Replies
CreatePlease to create content