11-13-2007 04:41 AM - edited 03-05-2019 07:23 PM
i had been using 2960 catalyst switch for connecting to server farm of late we
switched over to 6509 layer3 switch with sup32 engine how do i configure the device as layer2 because when i connect any host and access the net it gives request timed out
11-13-2007 04:56 AM
Hi,
Paragraph: Configuring LAN Interfaces for Layer 2 Switching.
Best regards.
Massimiliano.
11-13-2007 06:09 AM
By default, the switchports in the 6500 Series switch is set to Layer3 switchport.
To change from Layer3 to Layer2, you enter switchport on the intended interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: