Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration Question for 6509 switch

hello all,

I have a 6509 switch running Software 8.2(2) with 2 sup modules.

i am looking for a command that will show all the ip addresses that are mapped to all the ports on the switch.

Does such a command exist at all?

Thanks in advance.

2 REPLIES

Re: Configuration Question for 6509 switch

You can only check the MAC address --> port mapping on a layer 2 switch. 'show cam dynamic' will display all the MAC to port mapping. It's a two step process to find out which port on the switch a host is connected to. To find out which port a host is connected you need to get the MAC address of the device from the ARP table on the layer 3 gateway (Router/layer 3 switch like MSFC) by doing 'show ip arp' and then do a 'show cam (mac_address) vlan (id)'. If you know the MAC of the host you want to lookup the port then you can skip the first step.

HTH

Sundar

New Member

Re: Configuration Question for 6509 switch

I thought so.

Thanks a bunch....i wish cisco would come up with a command that would show all ip address that are specifically mapped to the ports.

266
Views
0
Helpful
2
Replies
CreatePlease login to create content