Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure BGP -Multihoming with full Auto Failure

Hi,

My curent requirement:-

Single Router at our premises - connected to Two ISP with two serial ports.

Looking for auto failure with BGP Multi homing in this scenario.

Do we need Public/Private AS in this requirement at our own permises.

Warm Regards!

3 REPLIES
Hall of Fame Super Silver

Re: Configure BGP -Multihoming with full Auto Failure

Hello Mirza,

if you are an enterprise, depending on your needs a setup using a private AS number and NAT with two pools one from each ISP can be enough.

see the following document

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_white_paper09186a0080091c8a.shtml

If you need an active/active solution probably you will need your own public AS number and your own address space.

a simple example of BGP multihoming

http://www.cisco.com/en/US/tech/tk365/technologies_configuration_example09186a008009456d.shtml

Hope to help

Giuseppe

New Member

Re: Configure BGP -Multihoming with full Auto Failure

Hello Giuseppe,

Thnaks for the above links! But it did not meet my requirement.

New Member

Re: Configure BGP -Multihoming with full Auto Failure

Plz Help on this requirement.

195
Views
0
Helpful
3
Replies