Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure CBQoS for monitoring.

  Hi, i want to configure CBQoS in a lot of 2960 switches (with snmp v1) for monitoring: jitter, delay and packets lost with PRTG software.

  I not found documentation for understand CBQoS, but i see this doc:

http://www.cisco.com/en/US/docs/ios/ios_xe/qos/configuration/guide/cbqos_mib_xe.html

  and when i put these commands:

1. enable

2. configure terminal

3. snmp-server ifindex persist

4. snmp mib persist [cbqos | v3mibs]

5. end

6. write mib-data

  I can't do the step 4

Switch(config)#snmp mib ?

  community-map     Community Mapping as per RFC-2576

  notification-log  Configure the Notification Log MIB

  rep               Enable SNMP Resilient Ethernet Protocol options

  target            target extention CLI from SNMP

PS: Or maybe is a simplest way to monitor QoS.

Thanks!

1 REPLY
New Member

Configure CBQoS for monitoring.

I realy sorry, i didn't realise for the IOS version. I'm replying myself:

  Upgrade IOS:

c2960-lanbasek9-mz.122-55.SE8

to

c2960-lanbasek9-mz.150-2.SE4

Switch(config)#snmp mib ?

  community-map     Community Mapping as per RFC-2576

  notification-log  Configure the Notification Log MIB

  persist           Persistence for MIBS

  target            target extention CLI from SNMP

Now, i wiil try to get work CBQoS.

Thanks

546
Views
0
Helpful
1
Replies
CreatePlease to create content