Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure cisco 1811 switch

Hello

I have a cisco 1811, and i want to configure the switch to use the ports in diferent VLAN's. lets say i have set the FE0 with the ip 20.20.20.254, this is were i get the information from.

the 8 ports that i have I want to divide in 3 VLAN's

port 2-3 10.10.10.0-10.10.10.63

port 4-5 10.10.10.64 - 10.10.10.127

port 6-9 10.10.10.128 - 10.10.10.255.

is this possible?

How do i separate in VLAN's?

do i have to configure the Vlans with the gateway address that each subnet will use and than route each gateway through the FE0 interface?

Please help me

regards

1 REPLY
Bronze

Re: configure cisco 1811 switch

refer to the sample configuration document which explains the steps the creating VLANs in 1800 device.

http://www.cisco.com/en/US/products/ps5853/products_configuration_guide_chapter09186a008045831d.html

537
Views
0
Helpful
1
Replies