Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure cisco 6500E model

Hi

I want to know how to configure cisco 6500E model switch which has both supervisor and line cards.

1 REPLY
Silver

Re: configure cisco 6500E model

Hi!

The configuration for these switches is the same as any other. The configuration is dont through console attached to the superviser itself.

You can configure any ports on the line card directly by goingt to interface configuration mode like "interface module no./port number.

Eg. A Lan line card with 24 ports present in module 3 can be configured through interface gig3/1 which refers to the 1st port on the 3rd linecard.

Similarly for WAN cards, its gi3/1/0 where 3 denotes the module number, 1 denotes the spa(sub module) number and 0 denotes thew port number on the spa.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_installation_and_configuration_guides_list.html

refer the above link for configuration guides!

Regards,

Niranjan

pls. rate helpful posts

116
Views
0
Helpful
1
Replies