Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure Etherchannel on LACP configured module on 6500

I setup a blade on my 6513 to use lacp for my SAN using the channelprotocol command. I now

need to setup an Etherchannel on the same blade between 4 ports but I get the error that it is configured as LACP. Is there any way to set specific

ports back to pagp so I can setup an etherchannel on these ports or do they need to go on a separate blade. I need etherchannel v.s. LACP because VMware ESX doesn't support LACP.

Thanks

Greg

3 REPLIES
Cisco Employee

Re: Configure Etherchannel on LACP configured module on 6500

Hi Greg,

If the 6500 is running native mode, you can configure lacp or pagp per port base.

HTH

Lei Tian

New Member

Re: Configure Etherchannel on LACP configured module on 6500

How can I determine that? The 6513 is running CATOS

Cisco Employee

Re: Configure Etherchannel on LACP configured module on 6500

If you are running CATOS, then it is not native mode. In catos, you cannot have different protocols running on same module.

HTH,

Lei Tian

1109
Views
0
Helpful
3
Replies
CreatePlease to create content