Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configure HSRP in a cat 3750 switch

What sofware version (ip-base, ip-services, SMI, EMI) I need to configure HSRP in a Catalyst 3750 stack?

Where can I find the differences between each version? I remember a web tool to compare features of each version in the cisco web but I don't fint it now

Thanks

3 REPLIES
Cisco Employee

Re: Configure HSRP in a cat 3750 switch

Hi,

HSRP is supported in c3750 EMI image version.

You can use Feature navigator to check the feature support. (You may need CCO login)

Regards,

Nagendra

Community Member

Re: Configure HSRP in a cat 3750 switch

Thanks, but in the feature navigator I can see HSRP in the ip-base image

Re: Configure HSRP in a cat 3750 switch

HSRP is supported in all three images (IP Base, IP Services & Advanced IP Services), You are limited to 32 HSRP instances though.

The main differences between the three versions are:

IP Base Unicast IP routing but support for RIP & Static Routing, IP Services & Advanced IP Services additionally support EIGRP, OSPF & BGP. (12.2(25)SE adds EIGRP Stub to IP Base

IP Base - no Multicast IP inter-VLAN routing (PIM Stub is supported from 12.2(25)SE), IP Services & Advanced IP Services additionally support full Multicast IP routing. All images support IGMP Snooping at layer-2

VRF Lite is supported on the IP Services & Advanced IP Services images, it's not available in the IP Base image.

Advanced IP Services adds IPV6 support.

HTH

Andy

689
Views
5
Helpful
3
Replies
CreatePlease to create content