Configure Trunk carrying same Vlans on two separate uplinks on Cisco 3845
I need to carry 2 vlans(x & y) in a trunk to two separate redundant devices uplinked to Cisco 3845 on Fa1/0 and Fa1/1. I know I can create sub-interfaces on one of the uplink interfaces(i-e Fa1/0) with 2 distinct 802.1q vlans(Fa1/0.x & Fa1/0.y). But is there a way I can carry same vlans(x & y) trunked to my 2nd redundant device uplinked on 3845 from Fa2/0 ? If not then how should I get the 2nd redundant device uplinked to this 3845 router.
No there are going to two different devices for redundancy. I might have to use IRB I guess but not sure if there is going to be any downside since we havn't used that type of solution in our enviornment before.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...