Re: Configuring a switch port to be a member of more than one Vl
Actually to answer your question, we should understand the reuqirement-
1) If you need multiple VLANs to be assign to the port as single point of time then it is not supported and not expected also. Only way is to have multiple VLAN on a port is - you create a trunk port but in that case your machine (NIC card ) should support trunking feature.
But if you are looking something like port need to be in different VLAN at different point of time then Yes you have option of dynamic VLAN, which assigne port to a particular VLAN depending on MAC address.
Lastly you can have two VLANs on a port possible -- that is Voice VLAN and other DATA VLAN.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...