Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring a WIC -1DSU T1 on 2610

I'm trying to configure a Serial port on this router but it's not taking the following statements:

Interface serial 0/0

service-module t1 clock source internal

service-module t1 framing esf

service-module t1 linecode b8zs

I don't get an error message but when I do a show run it doesn't show up. Is this a default?

1 REPLY
Hall of Fame Super Silver

Re: Configuring a WIC -1DSU T1 on 2610

Hello Roland,

yes these should be default settings

try to use

sh controller ser0/0 to check these parameters

Hope to help

Giuseppe

131
Views
0
Helpful
1
Replies
CreatePlease to create content