I am examining a requirement to configure C2960 as below
NTP internet sources > C2960 > Domain Controllers > other devices and servers
In theory what I am trying to achieve is to synchronize C2960 with multiple NTP internet sources which then would act as server and serve as NTP source to all windows domain controllers. Rest of the environment (other servers/host PC and switches) will synchronise with windows domain controllers to seek time.
Please could you advise how this can be achieved?
On the C2960 there is SVI available and routed for management access.
Following are options under interface Vlan
broadcast Configure NTP broadcast service
disable Disable NTP
Below on global config mode
access-group Control NTP access
authenticate Authenticate time sources
authentication-key Authentication key for trusted time sources
broadcastdelay Estimated round-trip delay
clock-period Length of hardware clock tick
logging Enable NTP message logging
max-associations Set maximum number of associations
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.