i have configured the VLANs on the MSFC and assigned respective IP addresses. I am able to ping the VLAN IPs from the edge switches in the same VLAN through a console port. Am using VLAN 60 as the Management VLAN.
The problem is I can't ping the edge switch directly connected to my laptop thro' Ethernet port and also laptops in the same VLAN can't establish a communication
1) Is your laptop in vlan 60 or a different vlan. If it's in a different vlan then
a) your laptop needs it default-gateway set to the L3 vlan interface on the MSFC for the relevant vlan
b) the edge switches each need their default-gateway setup to point to the L3 vlan interface for vlan 60 on the MSFC.
2) Are the links between your edge switches and the 6513 configured as trunk links and is vlan 60 + the laptop vlan allowed on that trunk.
3) When you say laptops in the same vlan can't establish communication do you mean
a) with each other ? - in which case are the laptops on different edge switches and if so check 2)
b) with the edge switches - check 1)
For devices to communicate within the same vlan they need an IP address from the same IP subnet. They also need their ports allocated to the same vlan and if they are on different switches then the links between the switches must be configured as either
a) access links for that vlan
b) trunk links
For devices to communicate from different vlans then you need to have L3 vlan interfaces for both devices, each device must have it's default-gateway set to their respective L3 vlan IP address.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...