You can configure the router by retrieving and modifying a configuration file stored on one of your network servers. To do so, complete the following tasks:
Copy the .txt file & paste into the tftp server.
Step 1 Enter configuration mode with the network option.
copy tftp running-config
Step 2 At the system prompt, select a network or host configuration file. The network configuration file contains commands that apply to all network servers and terminal servers on the network. The host configuration file contains commands that apply to one network server in particular. host or network
Step 3 At the system prompt, enter the optional IP address of the remote host from which you are retrieving the configuration file. Ip-address
Step 4 At the system prompt, enter the name of the configuration file or accept the default name. Filename
Step 5 Confirm the configuration filename that the system supplies : Y
In the following example, the router is configured from the file tokyo-config at IP address 10.108.2.155:
Router1# copy tftp running-config
Host or network configuration file [host]?
IP address of remote host [255.255.255.255]? 10.108.2.155
Name of configuration file [tokyo-confg]?
Configure using tokyo-confg from 10.108.2.155? [confirm] y
Booting tokyo-confg from 10.108.2.155:!! [OK - 874/16000 bytes]
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...