Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring cisco router 2911 with NAT

Hi

I have cisco router 2911 and cisco catalyst 3560G

i want to give my 5 client with corresponding 5Mbps each and 5Mbps for my office any of us must cannot see each other, all of this via either vlan or interface vlan

i want to give my client with static ip not DHCP for security purpose

Client Requirements:

- port forwarding for there internal purpose e.g: range port 3000 - 3050

- no filter, no firewall, no restriction, just open

- etc client must free for everything they want

Here's the available port on my router and switch:

router:

int gig 0/0 - WAN with ip 25.212.50.54 255.255.255.252

int gig 0/2 - LAN for NAT with ip 11.11.11.1 255.255.255.252

and i already configure cause we use it now:

ip route 0.0.0.0 0.0.0.0 25.212.50.54

switch:

int gig 0/14 - client 1

int gig 0/15 - client 2

int gig 0/16 - client 3

int gig 0/17 - client 4

int gig 0/18 - client 5

int gig 0/19 - office

int gig 0/20 - router to switch link

Every comment highly appreciated

Thanks

I know some but i am not an expert

212
Views
0
Helpful
0
Replies
CreatePlease login to create content