I have a problem. I'm doing a small lab for the courses. I need to create 4 DHCP pools for 4 VLAN's on Router0. And then to configure DHCP-relay agent on Router1, so PC's in VLAN 300 and 400 could recieve IP addresses from DHCP pools.
That's what I've done on Router0:
ip dhcp pool 100
network 10.10.192.0 255.255.240.0
ip dhcp pool 200
network 10.10.208.0 255.255.240.0
ip dhcp pool 300
network 10.10.224.0 255.255.240.0
ip dhcp pool 400
network 10.10.240.0 255.255.240.0
encapsulation dot1Q 100
ip address 10.10.207.254 255.255.240.0
encapsulation dot1Q 200
ip address 10.10.223.254 255.255.240.0
encapsulation dot1Q 300
ip address 10.10.239.254 255.255.240.0
encapsulation dot1Q 400
ip address 10.10.255.254 255.255.240.0
I also switched Switch0 and Switch1 ports which are connected to routers to trunk mode. But I don't understand, how I should configure DHCP relay agent on Router1 and which addresses I should give to the subinterfaces on Router1. I know you can use ip helper-address on Fa0/1 subinterfaces of Router1, but I'm kinda confused about the IP addresses of all subinterfaces. I really hope someone will help me with this problem!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.