Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Configuring etherchannel guard

I'd like to configure etherchannel guard between my distributions 6500 and my access 3750G switch. I also have some old 4912G connected to those distribution.

What will happen to the channels between the 6500 and the 4912G?

Also, when migrating...if the feature is only configure on one`side of the link...how will it behave.

1 REPLY

Re: Configuring etherchannel guard

There's no requirement to configure etherchannel guard on both ends. In fact configuring this feature on one end is sufficient as the 6500 would put the port in error disabled state if any etherchannel misconfiguration is detected and thus the correspondig port on the 4912 will go down and wouldn't cause any STP problems.

HTH

Sundar

151
Views
5
Helpful
1
Replies