Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Configuring Etherchannel

Hi,

I have two Fast ethernet interfaces on a WS-C2924M-XL acting as trunk ports and allowing multiple VLANs. I want to configure an etherchannel on these ports, but iam unable to do so.

Appreciate your help on this.

Regards

Navneet

1 REPLY
Cisco Employee

Re: Configuring Etherchannel

Navneet,

You have to use "port-group" command under the interface configuration mode on these old switches. Which device is there at the other end?

Please find the link below for ether-cahnnel configurations:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc3/sc/swgports.htm#xtocid13

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12119ea1/2950scg/swethchl.htm

HTH,Please rate if it does.

-amit singh

147
Views
0
Helpful
1
Replies
CreatePlease to create content