Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring HSRP w/ InterVlan Routing

I have configured HSRP with InterVlan routing. All communication is flowing properly between the vlan's on Router A but when I test failover to Router B I cant ping ANYWHERE. I cannot ping any of the VLANS.


Also, From the primary router I cannot ping any of the interfaces on the secondary router.


I have 2 Cisco 1921 Routers configured for HSRP. Both the G0/1 ports plug into a Cisco 2960S 48 port POE switch (STACKED) (port 1 and port 2 which are trunked and allowing all vlans to pass through. And both of the G0/0 ports are plugged into a Cisco ASA5510.


I have attached a diagram of the setup and the interface configs of the routers.


As for the ports 1 and 2 on the switch, the only commands on them are:


switchport mode trunk

switchport trunk native vlan 99

Any help is greatly apprectiated.. If you would like the actual router/switch configs please let me know.

1 REPLY
New Member

Configuring HSRP w/ InterVlan Routing

Hi,

when you test the failover what you made?

shut some port or power off one router?

Regards

1415
Views
0
Helpful
1
Replies