I am trying to build a remote connectivity to a set of standard devices to be configured for implementation and there is a requirement for a switch, firewall, VPN concentrator...etc to have an ip to be accessible remotely. The ip addresses will be leased from firewall acting as DHCP server. Can I have a switch to dynamically recieve an IP address from the DHCP server..? Can someone tell me if this could be done...?
It depends on the switch. The command is ip address dhcp on the VLAN interface. The DHCP server must be on the same VLAN, or must be helped by the router. But my old 2912XLs and 2950s will not accept the command.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...