I have two asa asa A and ASA b. my snmp server is in the n/w where asa A is placed. connectivity between both asa through isec vpn i try to monitor asa b from asa A side because my snmp server is behind the asa A. i am not able to ping the asa B. may someone tellme that what command i need to run on ASA B to connectect it with my snmp server.
Which interface of ASA B are you trying to ping? I assume the inside interface and it is the interface subnet that is part of the crypto ACL? If that is the case, have you configured "management-access inside" command on ASA B, that will allow you to ping the ASA B inside interface from ASA A LAN.
When you define the snmp server ip address on ASA B, you would need to configure the "inside" interface so it is sourced from the inside interface which again I assume is part of the crypto ACL interesting traffic for the VPN.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...