Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

configuring ntp

Hi all,

I have a cisco asa with 2 interfaces where first interface has an ip 1.1.1.1 and it points to ntp server 1.1.1.2 for time synchronisation.

ntp on my asa is configured as below and it works fine.

"ntp server 1.1.1.2 source inside"

This asa has a 2nd interface with ip 2.2.2.1/24 where i want all devices within the 2.2.2.0/24 network to synchronise its time to this asa.

I configured the below command to my devices within 2.2.2.0/24 network but the time doesn't sync. Pls advise. TIA!

"ntp server 2.2.2.1"

1 REPLY

As far as I know, ASA cannot

As far as I know, ASA cannot act as an NTP server but only NTP client. The NTP source only means that the ASA will get time from your 1.1.1.2 server using the INSIDE IP address.

54
Views
0
Helpful
1
Replies