Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring policy-map in 4503 switch

Hi, we trying to configure policy-map in 4503 switch and by applying through police we are experiencing packet drop.

config detail:

class-map match-any voice

description voice

match access-group 101

!

!

policy-map priortization

class voice

police 768000 bps 1000 byte conform-action transmit exceed-action drop

class class-default

police 7000000 bps 1000 byte conform-action transmit exceed-action drop

Please let us know what is the best method of configuring the same

thanks

2 REPLIES

Re: Configuring policy-map in 4503 switch

Which class are you seeing the drops?

Chnage your policy map to something like this

policy-map priortization

class voice

priority 768

class class-default

police 7000000 bps 1000 byte conform-action transmit exceed-action drop

The priority command will enable the class for priority queueing and will have an implicit policer as well.

Narayan

New Member

Re: Configuring policy-map in 4503 switch

hi, in this switch i can see only few option in policy-map

cat01(config-pmap-c)#?

QoS policy-map class configuration commands:

no Negate or set default values of a command

police Police traffic matching current class

set Set QoS values

dbl Dynamic buffer limiting

exit Exit from QoS class action configuration mode

trust Set trust value for the class

i dont see the priority or bandwidth option in this Version 12.2(20)EW4 switch.

thanks

210
Views
0
Helpful
2
Replies