Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring RSPAN with CIGESM & 6509

I'm trying to configure a RSPAN session to monitor traffic on a port on a Cisco IGESM module to a probe on a trunk port on a 6509. The following config has been applied but no traffic is not being seen on the 6509 port or the reflector port.

I have a set a relector port on the CIGESM module and assigned a new VLAN as below:

interface GigabitEthernet0/19

description REFLECTOR PORT FOR RSPAN MONITORING, DO NOT USE/ADJUST

switchport trunk native vlan 100

switchport mode trunk

switchport nonegotiate

CIGESM1_Apollo_Hall2#sh monitor session 1

Session 1

---------

Type : Remote Source Session

Source Ports :

Both : Gi0/10

Reflector Port : Gi0/19

Dest RSPAN VLAN : 100

The following is the config of the 6509 port:

interface GigabitEthernet2/45

description Compuware Probe

switchport

switchport trunk encapsulation dot1q

switchport mode trunk

no ip address

102
Views
0
Helpful
0
Replies