Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

neo
New Member

Configuring SNMP notification for Statefull Switchover on CatOS 6500

Does anyone know the equivalent command syntax to enable "ciscoRFSwactNotif trap" on a 6500 switch running CatOS. I need to be able to detect modules transitioning from active state to standby and vice versa. I have been able to enable traps for devices running IOS, the problem lies in doing the same for devices running CatOS.

Any one with a clue or a link with information that can help enable this feature?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Configuring SNMP notification for Statefull Switchover on Ca

Hey,

'set snmp trap redundancy' should enable traps for CISCO-RF-MIB, including ciscoRFSwactNotif. This notification only seems to be supported in CatOS 8.x and later, more details here:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/command/reference/setsn_su.html#wp1287367

ftp://incoming.cisco.com/pub/mibs/supportlists/wsc6506/wsc6506-supportlist-catos.txt

/Phil

2 REPLIES
Silver

Re: Configuring SNMP notification for Statefull Switchover on Ca

Hey,

'set snmp trap redundancy' should enable traps for CISCO-RF-MIB, including ciscoRFSwactNotif. This notification only seems to be supported in CatOS 8.x and later, more details here:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/command/reference/setsn_su.html#wp1287367

ftp://incoming.cisco.com/pub/mibs/supportlists/wsc6506/wsc6506-supportlist-catos.txt

/Phil

neo
New Member

Re: Configuring SNMP notification for Statefull Switchover on Ca

Hi,

Thanks for your prompt response, you are indeed a life saver. it works perfectly.

neo@cisco

262
Views
0
Helpful
2
Replies