Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Configuring SPAN port on 2980 Cat OS switch

Hi,

I need to monitor traffic on a Voice deditacted Vlan my network. I have set up a port on a 2980 switch with the following command:

set span 11(vlan) 2/28 and have connected a desktop to this port and am running ethereal on it but i am not getting any traffic for this vlan. We are having trouble with voice call on this vlan so i think something is causing excess traffic to occur.

Any idea what i'm doing wrong here not to be seeing any traffic? when there definatley is traffic on it?

Rob.

1 REPLY
Hall of Fame Super Bronze

Re: Configuring SPAN port on 2980 Cat OS switch

Can you post the show span output ?

Also, take a look at the documentation

http://www.cisco.com/en/US/docs/switches/lan/catalyst4000/7.5/configuration/guide/span.html

and see if any steps were missed.

HTH,

__

Edison.

243
Views
0
Helpful
1
Replies
CreatePlease to create content