We recently subscribed to 2 T1 (PPP) ckts through a service provider and were provided with the static IP addresses and ecapsulation type (PPP). I have installed 2 T1 (CSU/DSU) modules but I need to ensure that I have the correct configurations on these modules. Could someone please assist me in providing me with what I need to configure on the interfaces?
The syntax of what you need to configure varies somewhat based on what platform you are configuring. If you would tell us what model of router this is and what cards they are we might be able to give more specific advice. In general the things that you need to have in the config would include clock source, timeslots, framing (usually esf), and linecode (usually b8zs), encapsulation ppp, and IP address and mask.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...