07-21-2007 10:17 PM - edited 03-05-2019 05:25 PM
Can anyone let me know how to configure the management port present in SupV.
The interface does not seem to exisit when i do a show run.
is there any cisco doc to which someone can point me too
thanks
07-21-2007 11:31 PM
Hi,
The management port is used for IOS recovery. This port will only be active in ROMMON mode.
Please rate if this info was helpful.
Thanks
Deepinder Singh Babbar
07-22-2007 08:21 AM
Thanks for the info
But the link does not give any information about using the port in case of disaster
07-22-2007 10:24 PM
Check the below mentioned link that will help u in configuring MGMT Port in case of disaster.
Please Rate if info was helpful.
Thanks
Deepinder Singh Babbar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide